150W UNDERFLOOR HEAT MAT 10.0M2

150W UNDERFLOOR HEAT MAT 10.0M2

10.0m² Underfloor heating mat

MYHEAT® Classic is ideal for refurbishment projects in existing dwellings
or in new-build extension projects. Either as direct floor heating or as
floor storage heating.

There is no need to remove existing ceramic floor tiles - you can install the ‘ultra thin’ MYHEAT® Classic heating mats directly on top of the existing tiles and then tile over them as normal. There is normally no need to reduce door heights or raise skirting boards. MYHEAT® Classic is ideally suited to installation within the adhesive layer, the method preferred by professional floor tilers when laying ceramic tiles. MYHEAT® electric underfloor heating systems are clean, quiet in operation, 100% efficient at the point of use and requireabsolutely no maintenance at all.MYHEAT® underfloor heating is one of the most energy efficient means of heat delivery in existence.Installation into bathrooms and wet areas MYHEAT® Classic heating mats have an earthed metallic sheath beneath their outer jacket.MYHEAT® complies fully with the requirements of Section 601-09-04 ofthe IEE wiring regulations BS 7671:2001 and may be embedded in thefloor below any zone of the bathroom or shower room.Naturally, MYHEAT® Classic is the latest twin conductor design thatcomplies with the very latest EMC and electrical safety standards.Although we design and make our products in our UK factory we havethem tested by SEMKO, the national test laboratory, in Sweden, the‘spiritual home’ of electric underfloor heating.MYHEAT® Classic has a single earth-sheathed 3 metre long ‘cold tail’connections lead (only one connection cable to the thermostat).

MYHEAT® - Technical Data

Voltage: 230V ~ 50Hz
Protection against electric shock: Class 2
Earth shield: woven stainless steel braid.
1.0 mm2 csa connection lead < 1600 Watts
1.5 mm2 csa connection lead > 1600 Watts
Dielectric strength: 4000V dc between conductors and earth.
Leakage current between conductors and earth: < 0.5 mA
Insulation resistance: > 50 Meg. ohms at 500V dc Megger test.
(All information for guidance only).

Specification